303 221 2394


  • Pentax 67 Custom Light Seal Kit

Pentax 67 Custom Light Seal Kit

USCamera custom light seal kit for the Pentax 67 film cameras. This seal kit consists of 3  door channel seals on the camera body, 1 back cover hinge seal, 2 back cover door channel seal, 1 camera body door latch seal and 1 replacement mirror cushion. 

In stock (can be backordered)

  • Description
  • Additional information
  • Reviews (0)


Pentax 67 Custom Light Seal Kit

Pentax Film Cameras
Top Quality kit using imported open cell foam.
For help installing light seal kits go here.

Pentax ME ME Super MG Plus More Custom Light Seal Kit

Custom Light seals Pentax Film Cameras
USCamera has thousands of new and used Pentax film camera parts.

Please Contact us for any questions you may have. New light seal kits and parts are added every day from customer requests.  .See all USCamera light seal kits available for Pentax

“The most important and time consuming work is removing the old seals. Focus on clean, clean, clean. Clean the old residue from the door channels, mirror cushion area, door hinge area and anywhere else you are replacing the seals. The finest adhesive in the world will not adhere to that sticky, gooey residue that was once a quality light seal. Proper installation will give you thousands of light tight exposures.”

Always exciting, see what’s new with Pentax imaging products

USCamera Custom Light Seal Install – Pentax 67 

Before you do anything, please read general removal and installation instructions here.

Next, take all of the seals out of the kit and lay them out on your work area. This kit includes,

1 x 1mm – short, upper door channel seal, body
1 x 1mm – long, upper door channel seal, body
1 x 1mm – long, lower door channel seal, body
1 x 2mm – hinge seal, back cover
2 x 2mm – upper / lower, door channel seal, back cover
1 x 1mm – back cover seal, door latch, body
1 x 2mm – mirror cushion

Tech Note. It is easier to install the door channel seals and check the door latch felt on the body by first removing the door latch assembly. Open the back cover. Carefully peal back the front leatherette door latch side, where the body meets the latch assembly. That will expose the 3 latch assembly retaining screws. Look for washers under the latch assembly.

Door channel seals, upper/lower body. Install the short 1mm upper seal starting at the hinge side to the counter lever opening. Install the last upper channel seal from the counter opening left to the end of the channel then install the lower door channel seal.

Hinge seal, back cover. Install this seal, centering it between the upper and lower door channels on the back.

Door channels seals, upper/lower back cover. Install these short seals in the back cover door channels butting them up against the door hinge seal.

Door latch seal, body. This seal is included in the kit however the original is made of a felt type material and should only be replaced if missing.

Mirror cushion. Only one small cushion is used on this camera. Looking at the from the bottom of the camera and up into the focusing screen area, the mirror cushion is located on the far right side.  This seal is difficult to remove completely.  What we did for years was to make sure to remove as much of the old foam as possible, then install the new cushion just left of the old cushion.  Tech Note. Using a dental mirror or a small piece of mirror taped to a wood dowel makes it much easier to install and look at the mirror cushion location.

Pentax 67 Custom Light Seal Kit

Additional information

Weight 1 oz


There are no reviews yet. Add a review

Welcome to USCamera. Our imaging parts and information superstore. New product added everyday. Need something not listed? Email us with your request. Dismiss