USCamera Light Seal Placement Guide | Konica C35

USCamera Light Seal Placement Guide | Konica C35

Custom light seal kits for Konica film Cameras

For help installing light seal kits please go here.  Following the link to that short read can improve the quality of your light seal installation.

For more information on purchasing this kit, go here

Do you want to make your own light seal kit? Maybe you have a special film camera accessory that requires a special size of the light seal material.  We can help.

Sometimes sheet foam is the best solution. We have foam in 1mm, 1.5mm, 2mm, 3mm, and 4mm thickness available here.

In addition, we have many different strips of light seal material already cut to width and 220 mm long here.

For help installing light seal kits please go here.  Following the link to that short read can improve the quality of your light seal installation.

USCamera light seal kit placement guides can really help you also. Especially if the old light seals have already been removed before you acquired the camera. go here

You are installing a 5 piece kit for the Konica C35

This light seal kit includes,

Top channel seal, back cover – 1 x 2mm
Bottom channel seal, back cover – 1 x 2mm
Baffle plate seal, hinge end, back cover – 1 x 2mm
Latch plate baffle seal, latch end, back cover – 1 x 3mm

Hinge seal, camera body – 1 x 1mm See note

The most important and time consuming work is removing the old seals. Focus on clean, clean, clean. Clean the old residue from the door channels, mirror cushion area, door hinge area and anywhere else you are replacing the seals. The finest adhesive in the world will not adhere to that sticky, gooey residue that was once a quality light seal. Proper installation will give you thousands of light tight exposures.

See all USCamera light seal kits for Konica and more, start here.

USCamera | Thousands of parts for cameras, flash, lens, light seals, foam sheets, downloads + more | USCamera Light Seal Placement Guide | Konica C35