Canon CD3-4070 Card Cover
Canon EOS 6D Set Button
Canon CB5-5921-000 Black Screw
Canon XA1-3170-306 Chrome Screw
Canon A-1 Light Baffle Mirror Cage
USCamera Canon A-1 mirror cage light baffle. This baffle sheet is on the inside of the mirror box on the left side. The anti-reflective sheet Canon used had a tendency to curl as it ages. This replacement part from USCamera is a special type of poly-urethane material that was used in many film cameras produced in the 1980's and later. Just a couple camera models where I can see this baffle material was used is Nikon N2000, N2020, and later used in the Minolta XE-7 as an updated replacement part. Black adhesive tape has already been applied so to install just, peel material from the backing to apply. I strongly recommend an adhesive delay so you have time to align the baffle in place. Material made in Japan for USCamera.
Canon CY2-0594 Wind Lever Cover
Canon CA1-4949 Rewind Shaft
Canon X91-1736-220 Film Camera Screws
Genuine Canon camera screws for the AE-1, AE-1 Program, Al-1, AT-1, and the AV-1 film cameras. Package of 1 screw sold as pictured. Made by Canon Japan.
These screws fit the following locations on A-Series cameras,
- AE-1 Program - front apron, top cover, bottom cover
- AE-1 - front apron, top cover, (does not fit the AE-1 bottom cover)
- AL-1 - front apron, top cover, bottom cover
- AT-1 - front apron, top cover, (does not fit the AT-1 bottom cover)
- AV-1 - front apron, top cover, bottom cover
Canon CY3-1384 Back Cover
Genuine Canon replacement back cover shell for the EOS Rebel 2000, and the EOS 300 Non-QD (Quartz-Date) film cameras. Made by Canon Japan.
Please Note. The film reminder is already installed. You will need to transfer the pressure plate and other small parts from your old back cover to the new back cover.
Canon CF1-5034 Battery Cover
Canon CB1-3357 Film-Cartridge Contact
Genuine Canon replacement film cartridge contact for the EOS Rebel G, G II, G QD, and the EOS 500N film cameras. When a film cartridge is installed, this contact closes so when the back cover is closed the camera will preload. The most common problem when this contact is damaged or broken... the camera will not pre-load the film to frame 1.
