Yashica Electro 35 Light Seal Placement Guide
Yashica Electro 35 Light Seal Placement Guide
Custom Light seals Yashica Film Cameras
Yashica Electro 35 Light Seal Placement Guide
New and used Yashica film camera parts.
For help installing light seal kits please go here. Following the link to that short read can improve the quality of your light seal installation.
Please Contact us for any questions you may have. Also, new light seal kits and parts are added every day.
For more information on purchasing this kit, go here
Top Quality kits using imported open cell foam.
Do you want to make your own light seal kit? Maybe you have a special film camera accessory that requires a special size of the light seal material. We are here to help.
Sometimes customers find sheet foam is the best solution. We have photo grade sheet foam material with adhesive, in a thickness of 1mm, 1.5mm, 2mm, 3mm, and 4mm available here.
In addition, we have many different strips of light seal material already cut to width and 220 mm long here.
USCamera light seal kit placement guides can really help you.
Especially if the old light seals have already been removed before you acquired the camera. go here
See all USCamera Light seal kits available for Yashica
USCamera Light Seal Placement Guide | Yashica Electro 35
This USCamera custom 6 piece light seal kit fits the Yashica Electro 35, Yashica G, GS, GSN, GTN, GL, MG-1, and CC. This kit includes,
Lower channel seal on the camera body – 1 x 1mm
Upper channel seal on the camera body – 1 x 1mm
Hinge seal, back cover, hinge end – 1 x 2mm
Latch plate seal, back cover – 1 x 2mm. see Tech Note
Bottom channel seal, back cover latch end – 1 x 2mm
Top channel seal, back cover latch end – 1 x 2mm
Tech Note. Please note in order to cover all of the Electro 35 Models made, the bottom channel seal is longer than the top for the oldest models. If you are installing this kit on a later model, you will need to adjust the length when installing this seal.
General Installation Guidelines
Door latch seal, back cover. Tech Note. On the back cover, door latch side, there is a channel where a felt type material is used as a light seal. This seal does not need replacement as it does not wear out. A foam seal 47mm L x 2mm W x 2mm T has been included in this kit If this seal is missing or damaged. Again only replace this seal if it missing or damaged.
Door channel seals, at door latch end, back cover. Install these seals, latch end of the back cover, above/below the door latch starting 5mm from the edge of the door channel.
Door channel seals, camera body. Install the upper and lower back cover channel seals starting at the hinge side on the camera body, working from right to left. The upper channel has the counter actuation lever. You will need to install this seal as close to each side of the counter lever opening as possible.
Hinge Seal, back cover. Install this starting at the top edge of the back cover, hinge side and work your way down.
The most important and time-consuming work is removing the old seals. Focus on clean, clean, clean. Clean the old residue from the door channels, mirror cushion area, door hinge area and anywhere else you are replacing the seals. The finest adhesive in the world will not adhere to that sticky, gooey residue that was once a quality light seal. Proper installation will give you thousands of light tight exposures.
USCamera | Thousands of parts for cameras, flash, lens, light seals, foam sheets, downloads + more | USCamera Light Seal Placement Guide | Yashica Electro 35
USCamera Since 1998 | Service Parts for Cameras Lenses | Light Seal Kits | Vintage Film Cameras
Lastly, always made to inspire…see New film camera products.
