Canon A-1 Light Baffle Mirror Cage
USCamera Canon A-1 mirror cage light baffle. This baffle sheet is on the inside of the mirror box on the left side. The anti-reflective sheet Canon used had a tendency to curl as it ages. This replacement part from USCamera is a special type of poly-urethane material that was used in many film cameras produced in the 1980's and later. Just a couple camera models where I can see this baffle material was used is Nikon N2000, N2020, and later used in the Minolta XE-7 as an updated replacement part. Black adhesive tape has already been applied so to install just, peel material from the backing to apply. I strongly recommend an adhesive delay so you have time to align the baffle in place. Material made in Japan for USCamera.
Canon CA1-0977-031 LED Cover
Premium Import battery check LED cover ring for the Canon A1 film cameras. Made by USCamera China.
The cover ring is held in place with a small amount of contact cement. Please note 2 sizes of this cover were used. This is the small cover measuring 3.1mm.  If you don't know the measurement of your cover just measure the LED.  It should measure a little less than 3.1mm or 3.3mm. Only the 3.1mm small cover is available.
Canon CA1-4727 Film Sprocket
Canon CA1-4949 Rewind Shaft
Canon CA1-6504 Accessory Shoe
Canon CA4-1847 Terminal Cover
Canon CB1-2553 Grip Contact
Canon CB1-3357 Film-Cartridge Contact
Genuine Canon replacement film cartridge contact for the EOS Rebel G, G II, G QD, and the EOS 500N film cameras. When a film cartridge is installed, this contact closes so when the back cover is closed the camera will preload. The most common problem when this contact is damaged or broken... the camera will not pre-load the film to frame 1.