Olympus 35 RC 35 RD Placement Guide

Olympus 35RC 35 RD Placement Guide

USCamera Light Seals | Kits | Olympus Film Cameras
Olympus 35RC 35 RD Placement Guide | USCamera Foam

Before doing anything, please read about seal removal and installation. Go here.

Also, more information is available on purchasing these light seal kits.  35 RC here and 35 RD here.

Therefore, please Contact us with any questions you may have. New downloads, light seal kits and also parts are added to our online inventory almost every day.

You are installing a 6 piece kit for the Olympus 35 RC 35 RD Rangefinder

lower channel seal, latch end on the camera body – 1 x 1mm (See note concerning placement on Placement Guide)
bottom channel seal, back cover – 1 x 1mm
upper channel seal, back cover – 1 x
film cassette pressure foam, back cover – 1 x 2mm
latch plate seal, back cover – 1 x 2mm
door hinge seal, camera body – 1 x 1mm

Top Quality Light Seals | Premium Imported Open Cell Foam

In addition, see all USCamera Light seal kits available for Olympus. Go here

First of all, the most important and time-consuming work is removing the old seals. Focus on clean, clean, clean. Also, pay careful attention and clean all old residue from the door channels, mirror cushion area, door hinge area and anywhere else you are replacing the seals.

You need to understand the finest adhesive in the world will not adhere to that sticky, gooey residue that was once a quality light seal. Finally, an accurate installation will give you thousands of light tight exposures.

See all USCamera light seal kits for Olympus and more. Start here.
Olympus 35 RC 35 RD Placement Guide, USCamera Light Seals

Olympus is much more than imaging products, see for yourself.

USCamera | Thousands of parts for cameras, flash, lens, light seals, foam sheets, downloads + more | Olympus 35RC Placement Guide |

Olympus 35RC Placement Guide | Premium Quality Open Cell Foam Lasts Years. Also Same High-Quality Japanese Foam As Original | Canon Film Cameras | USCamera Foam